Thanks Rich
What you suggested is where I thought it should be.
I had off today (77 degrees) and went to the boat (2 hr road trip).
(Applied Poli Glow that looks very good.)
Ran into the Marina manager who confirmed the location of the T for water pickup in relation to the anti-siphone valve.
Rick
On Wed, Mar 26, 2008 at 9:11 AM, < ([email][/email])> wrote:
Quote:
I think it means that you place it somewhere between the raw water pump and the anti-siphon loop; after the heat exchanger sounds fine. Otherwise any leak in your shaft seal will fill your engine exhaust and may backup into your engine. On my engine, the exhaust riser is above the waterline so it would be odd for water to backup in there, but your installation may be different.
Original message
<.. snip>
—
Rich Carter
Original message
<.. snip>
Post generated from Pearson424 Forum using Mail2Forum