Hi Rick,
Good to know – mine is 'in progress' – the monitor is mounted and the holding tank is taped. Wiring and sensors for other tanks coming real soon now.
Bob
On Tue, Jun 17, 2008 at 7:29 PM, Rick Dugger < ([email][/email])> wrote:
I installed the 1-8 tank SCAD monitor this winter with sensors on 2 of the 3 water tanks. I liked the potential to add fuel, waste and propane at a later date. Installation was not bad. Instructions were very precise and clear. So far it works as advertised.
Rick
Eclipse #73On Tue, Jun 17, 2008 at 6:14 PM, svtopaz < ([email][/email])> wrote:
I found a kink in the overflow loop. I replaced it but have not check to see if it makes a diference. I am going to put new o-rings in. I would love to have the stainless plates but it is to much $$$. Same with the gauges. The hose I replaced was very dirty and very old. Some one also told me about a fitting I can put on my hose to keep the pressure at a certain level. Think I will look into that also.
Barbara
—
Bob Fine
Fine Software LLC
Your data on the web your way. No kidding
Post generated from Pearson424 Forum using Mail2Forum