- This topic has 2 replies, 2 voices, and was last updated 12 years, 5 months ago by
.
-
Posts
-
-
I know it’s been a while, but a couple years ago we were talking about replacing the bow chocks. Has anybody found a suitable replacement in size for the 424?
I broke one of mine and my welder , who is very good , has not been able to successfully weld whatever kind of metal those are made from.
AlanSent from my iPhone
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
Post generated from Pearson424 Forum using Mail2Forum
-
Several years ago, I had to replace both Bow chocks and I think I found the chocks at defender industries. I know I found them on-line. The replacements we exact replacements and used the same holes. It may take some research, but you should be able to find exact matches.
s
Original Message
Post generated from Pearson424 Forum using Mail2Forum
-
I have seen chocks for 1 1/4 line. But none that have a 6 inch bolt center.
All of them stainless, which would not be a problem. I suppose I could drill a new hole. That would not bother me either.
AlanSent from my iPhone
Quote:On May 17, 2014, at 7:45 PM, “Steven Weinberg, Ph.D.” wrote:Several years ago, I had to replace both Bow chocks and I think I found the chocks at defender industries. I know I found them on-line. The replacements we exact replacements and used the same holes. It may take some research, but you should be able to find exact matches.
s
Original Message
Post generated from Pearson424 Forum using Mail2Forum
-
- You must be logged in to reply to this topic.