- This topic has 1 reply, 1 voice, and was last updated 11 years, 1 month ago by
.
-
Posts
-
-
Hi All,
I have a used BW Velvet drive I picked up cheap and want to test it out.  First question, anyone know how to do this without just disassembling the unit?
I read a recommendation online that you could test one by connecting a power source to the input shaft of the transmission to see if the output spins, etc. However to do that I need to fit something over the input shaft which I understand could be rigged up with an old damper plate.
So anyone have a used or broken damper they can off?
ThanksSkip
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
Post generated from Pearson424 Forum using Mail2Forum
-
,Skip,
Unfortunately both my old damper plates went into the dumpster years ago.
You might check with a VD dealer in your area to see how much it would cost
for them to check it out.Regards,
John Stevenson
http://www.svsarah.com
Sarah’s Blog <http://www.sailblogs.com/member/svsarah/>On Mon, Sep 14, 2015 at 11:20 AM, Skip MacElhannon via maillist <
> wrote:Hi All,
I have a used BW Velvet drive I picked up cheap and want to test it out.
First question, anyone know how to do this without just disassembling the
unit?
I read a recommendation online that you could test one by connecting a
power source to the input shaft of the transmission to see if the output
spins, etc. However to do that I need to fit something over the input
shaft which I understand could be rigged up with an old damper plate.
So anyone have a used or broken damper they can off?
ThanksSkip
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
Post generated from Pearson424 Forum using Mail2Forum
-
- You must be logged in to reply to this topic.