Forums › General Discussion › Emailing: 009 › Re: Emailing: 009

#69309
RichCarter
Participant

Yuk!
My experience with the pedestal has been all bad. Aluminum and stainless don’t like each other. If left in contact with each other, electrolytic corrosion marries the two metals, making it near impossible to remove anything. The right way to do this is to put a stainless insert in the aluminum rather than tap a hole. Most manufactures don’t do this. If you heat a stuck fastener, you can sometimes remove it. Even if the fastener has a stainless nut on a stainless bolt as shown in your photo, you should expect difficulty removing it. When you reassemble, do the next owner a favor and put some goop on the threads.

I paint my pedestal in-place. I’ve run a bead of caulk around the base to keep water out from under it. If you can keep water out of there with caulking, you should be able to do the same.

—
Rich Carter


Original message


<.. snip>

Post generated from Pearson424 Forum using Mail2Forum