Watermaker — product water question

This topic has 1 reply, 2 voices, and was last updated 9 years, 6 months ago by unabated.

Viewing 1 reply thread

Author

Posts
- April 6, 2017 at 2:06 pm #222923
  
  Rob Osterman
  Participant
  
  Hello,
  
  I’m installing an engine-driven RO water maker and am trying to decide how to plumb the product water lines.
  
  Those of you who installed a water maker, did you plumb the product water directly to the tanks? I’m considering re-using the existing domestic water manifold before the domestic pump but am unsure if there is too much head pressure for the product water to fight against.
- April 6, 2017 at 2:33 pm #222925
  
  unabated
  Participant
  
  I installed the T valve so I can decide which tank the product water. Therefore the product water goes directly to the tank. remember you’ll need product water to run back through the pump when you’re done. That same tap you use to get product water out of you’ll need to test the water before you start pumping it into the tank.
  
  Hope that makes sense.
  
  Alan
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.