Propeller Offset photo – zinc placement

This topic has 1 reply, 2 voices, and was last updated 18 years, 5 months ago by RLeeds.

Viewing 1 reply thread

Author

Posts
- May 13, 2008 at 11:54 pm #66996
  
  RichCarter
  Participant
  
  Rodd
  I called my prop shop (H&H Salem MA) and asked them. They said that the
  zinc needs to be a minimum of 3/8″ from the strut. I’m about a half inch.
  
  The prop should be no more than 2.25 inches from the strut on the other end.
  That can be hard to manage with the spurs. I’m probably closer to 3″.
  
  Rich
  
  Quote:
  
  Original Message
  
  <.. snip>
  
  Post generated from Pearson424 Forum using Mail2Forum
- May 14, 2008 at 1:46 am #69876
  
  RLeeds
  Participant
  
  ok Thanks ! BTW I had to replace the small nylon noise stoppers on the
  stationary cutter this year– be careful that they are not too low or you
  will get excess noise.
  
  Original Message
  
  Post generated from Pearson424 Forum using Mail2Forum
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.