×

Propeller Offset photo – zinc placement

Home / Topic / Propeller Offset photo – zinc placement

Forums › General Discussion › Propeller Offset photo – zinc placement

Viewing 1 reply thread
  • Author
    Posts
    • May 13, 2008 at 11:54 pm #66996
      RichCarter
      Participant

      Rodd
      I called my prop shop (H&H Salem MA) and asked them. They said that the
      zinc needs to be a minimum of 3/8″ from the strut. I’m about a half inch.

      The prop should be no more than 2.25 inches from the strut on the other end.
      That can be hard to manage with the spurs. I’m probably closer to 3″.

      Rich

      Quote:
      Original Message

      <.. snip>

      Post generated from Pearson424 Forum using Mail2Forum

    • May 14, 2008 at 1:46 am #69876
      RLeeds
      Participant

      ok Thanks ! BTW I had to replace the small nylon noise stoppers on the
      stationary cutter this year– be careful that they are not too low or you
      will get excess noise.

      Original Message

      Post generated from Pearson424 Forum using Mail2Forum

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.