Forums › General Discussion › hot engine hard to turn over › Re: hot engine hard to turn over

#70465
john stevenson
Participant

Rick,
Any further developments on this issue? If the G27 batteries can start the engine once it cools without any charging, then I have to agree with Bob that is likely a heat related problem – most likely in the starter.

However, I did have a problem on a previous boat, that initially acted like your problem. The wire terminal which attached the boat ground to the engine block had cracked and nearly separated. Therefore most of the amps for the starter motor were flowing for the physical contact of the lug terminal lying on top of the engine. The engine would start dockside, but when I needed to restart on returning to the marina it would randomly not start. Fortunately that was a 2-cylinder engine and I could hand crank it. I got really good at hand cranking the engine that summer. At first I thought the problem was linked to a warm engine, but as the lug terminal worked it's way toward total separation, but failure to start became more random and no longer consistent with engine operation.
I trouble shot the problem all summer, but never once thought to check the boat ground. Finally I gave up and turned in a work order to the boat yard. The mechanic took the started off the engine and bench checked it with no problem found. Then after re-installing the starter and the engine continuing to not start he took a slight tug on the boat ground and this time the terminal separated and the ground wire came loose from the engine block. He replaced the lug terminal and re-secured it to the block and I never had a starting problem thereafter.
Needless to say I was embarrassed to have not tested the most basic electrical troubleshoot step for an entire summer. If your problem continues to be consistent with the engine being warm, then this is likely not the source of the problem. However, a good tug on both the engine and battery terminals is probably worth doing.

John

On Sat, Aug 9, 2008 at 6:50 PM, Rich Carter < ([email][/email])> wrote:

Quote:
Rick
From your description, I can't tell how you have your batteries connected. I use a separate starter battery that does nothing but start the engine. It doesn't run anything else. This insures that no matter how much I run the house batteries down, I can start the engine. The boat didn't come this way. It came with a pair of 8D deep-cycle batteries in the starboard locker. I found that these batteries weren't very good for starting the engine. They don't have enough cold-cranking capacity and they can get run down. What you really want is a starter battery for starting the engine and deep cycle batteries for house batteries. I use a generic truck starter battery. The largest starting battery that Sams Club sells. Hooking an isolated battery up like this can be expensive or complicated but there is at least one simple way to do this using a solenoid switch.

It sounds as if you have an electrical problem somewhere; perhaps a loose connection somewhere in your starter circuit. Try cleaning the terminals off with sandpaper and tightening them back up. The next time the engine fails to crank, try shorting out the starter solenoid. You may have an issue there.

Regards
Rich – BlackSheep

Quote:
<.. snip>

Post generated from Pearson424 Forum using Mail2Forum