- This topic has 5 replies, 2 voices, and was last updated 17 years, 1 month ago by
.
-
Posts
-
-
Does anybody know where I can get one or two of those 8″ aluminum cleats (originally painted black) that
Pearson used on the aft and side cockpit combings? Are they still manufactured? Anyone have an unwanted one
(or pair) laying around?Tor
~~~~~~~~~~~~~~~~~~~~~~~
Silver Heels, P-424 #17
http://www.SilverHeels.us
~~~~~~~~~~~~~~~~~~
To unsubscribe, e-mail:
For additional commands, e-mail:Post generated from Pearson424 Forum using Mail2Forum
-
I think I have two of those. I’ll measure them and get back with you.
Lee
<.. snip>
Post generated from Pearson424 Forum using Mail2Forum
-
I measured and what I have is two each 10″ aluminum cleats and two each 9 1/4 inch aluminum cleats.
Lee
<.. snip>
Post generated from Pearson424 Forum using Mail2Forum
-
Lee,
Thank you very much for checking. I was mistaken about the measurements… twice. The side cleats and aft quarter cleats are not the same size. I just went out and measured. The quarter cleats aft, intended for dock lines, are 9-1/4″. The cockpit combing side cleats, originally installed as genoa sheet cleats, are 7-3/4″. It is these smaller cleats that I hope to match. The 10″ cleats you have were the original bow cleats, intended for anchor rodes, etc.
Alas, what you have I can’t use, and what I can use you don’t have. Cruel, cruel world!
Tor
~~~~~~~~~~~~~~~~~~~~~~~
Silver Heels, P-424 #17
http://www.SilverHeels.us
~~~~~~~~~~~~~~~~~~
Original Message
<.. snip>Post generated from Pearson424 Forum using Mail2Forum
-
-
Thanks, Quent. I suspect you’re right about the brand since the styling is consistent.
Tor
~~~~~~~~~~~~~~~~~~~~~~~
Silver Heels, P-424 #17
http://www.SilverHeels.us
~~~~~~~~~~~~~~~~~~
Original Message
<.. snip>Post generated from Pearson424 Forum using Mail2Forum
-
- You must be logged in to reply to this topic.