- This topic has 1 reply, 2 voices, and was last updated 15 years, 9 months ago by
.
-
Posts
-
-
This weekend I removed all hardware from main and mizzen boom in preparation to sand and paint the booms. Any suggestions on best option to refinish the Aluminum castings? Powder coat epoxy / hard anodize or just paint them too.
Eric
Navasana
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
Post generated from Pearson424 Forum using Mail2Forum
-
I had mine sand blasted and hard anodized… looks good. Could have had them
painted with the same awlgrip we used on the spars too. in fact i did do
that to one piece. when i re-assembled i put 3m isolation tape around the
caps first, almost all slid in easily.-p
—
s/v Deep Playa | Pearson 424 Hull #152 | http://www.DeepPlaya.comOn Mon, Jan 10, 2011 at 3:58 PM, S V Navasana wrote:
This weekend I removed all hardware from main and mizzen boom in
preparation to sand and paint the booms. Any suggestions on best option to
refinish the Aluminum castings? Powder coat epoxy / hard anodize or just
paint them too.Eric
Navasana
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
Post generated from Pearson424 Forum using Mail2Forum
Owners no more...
Thanks Dawn and Patrick!
-
- You must be logged in to reply to this topic.