Cutless bearing and backstay chainplate

[RichCarter]

I just ordered a replacement zinc and bearings for my spurs line cutter. While I was on the phone with the prop-shop, I asked them a couple of questions about the cutless bearing. The bearing should be inserted without lubricant and it should be a press fit. Rod’s installation sounds like it is the right way to go.

I spent the weekend building a new backstay chainplate and associated hardware. Photos will follow.
—
Rich Carter

---

To unsubscribe, e-mail:
For additional commands, e-mail:

Post generated from Pearson424 Forum using Mail2Forum

[Author]

Posts