- This topic has 10 replies, 4 voices, and was last updated 16 years, 3 months ago by
.
-
Posts
-
-
-
Wow, Alan, that's tiny! I thought you'd be filling the entire lazarette with generator and parts! Just out of curiosity, how much did the generator cost?
Regards,
Bob
On Sun, Aug 30, 2009 at 6:37 AM, Alan < ([email][/email])> wrote:
Two weeks before I leave and I finally got the Generator in the boat……. Here's a picture of it sitting in the aft lazerette.
I have more pictures of the engine bed and mounts if anyone is interested.
alan
UNABATED
To unsubscribe, e-mail: ()
For additional commands, e-mail: ()—
Bob Fine
s/v Pelican
Hull #8Post generated from Pearson424 Forum using Mail2Forum
-
If (when) I finally have to pry my NL genset out of the lazerette That's what I would want to replace it with. Suddenly I would no longer have to hang my fenders on the stern rail.
Actually that might become crew quartersOn Sun, Aug 30, 2009 at 9:24 AM, Robert Fine < ([email][/email])> wrote:
Wow, Alan, that's tiny! I thought you'd be filling the entire lazarette with generator and parts! Just out of curiosity, how much did the generator cost?
Regards,
Bob
On Sun, Aug 30, 2009 at 6:37 AM, Alan < ([email][/email])> wrote:
Two weeks before I leave and I finally got the Generator in the boat……. Here's a picture of it sitting in the aft lazerette.
I have more pictures of the engine bed and mounts if anyone is interested.
alan
UNABATED
To unsubscribe, e-mail: ()
For additional commands, e-mail: ()—
Bob Fine
s/v Pelican
Hull #8—
Regards,
John Stevenson
http://www.svsarah.comPost generated from Pearson424 Forum using Mail2Forum
-
Alan,
I was surprised by its size, too. What model / KW rating is that?
Tor
~~~~~~~~~~~~~~~~~~~~~~~
Silver Heels, P-424 #17
http://www.SilverHeels.us
~~~~~~~~~~~~~~~~~~Quote:
Original Message
<.. snip>Post generated from Pearson424 Forum using Mail2Forum
-
-
Kubota EL300 – supposed to be either a 5 or 6 HP.
I had to marineize it. I didn’t have alot of time so I bought the heat riser. Purchased the heat exchanger. Both from NextGen.
Small Centrek Water muffler…….
a— On Sun, 8/30/09, Silver Heels <> wrote:
Quote:<.. snip>Post generated from Pearson424 Forum using Mail2Forum
-
Where’s the starter Alan?
What did you end up using and paying for the wet exhaust pipe/elbow?Pete
Alan wrote:
Two weeks before I leave and I finally got the Generator in the
boat……. Here’s a picture of it sitting in the aft lazerette.
I have more pictures of the engine bed and mounts if anyone is interested.
alan
UNABATED
To unsubscribe, e-mail:
For additional commands, e-mail:
To unsubscribe, e-mail:
For additional commands, e-mail:Post generated from Pearson424 Forum using Mail2Forum
-
-
Great idea using the loop of the starter bracket as a lifting ring.
Alan wrote:
Quote:At the time the pictures were taken, we had removed the starter and
used that bracket to lower the engine into the locker. Lots of room to
lower it……— On *Sun, 8/30/09, Pete Dubler /<>/* wrote:
<.. snip>
Post generated from Pearson424 Forum using Mail2Forum
-
Dayum. I’ve been looking on ebay for like three years and I’ve never seen one for less than 500.
On 8/30/09 7:01 AM, Alan wrote :
Quote:200 off ebay…. was from a construction arrow board that some lady ran into and smashed to bits but they were able to save the engine.
a— On Sun, 8/30/09, Robert Fine <> wrote:
Quote:<.. snip>Post generated from Pearson424 Forum using Mail2Forum
-
-
- You must be logged in to reply to this topic.