- This topic has 3 replies, 3 voices, and was last updated 18 years, 4 months ago by
.
-
Posts
-
-
Perhaps some of you might profit from a recent experience of mine.
On a fairly windy day, while rolling up the jib, a flailing jib sheet broke one of my lifelines at the connection to a gate eye. Inspection of the broken wire revealed that all the strands were badly corroded. My boat is a 1980 (built in 1979) and I believe the lifelines were the original ones.Needless to say the lifelines have now been replaced. The new ones have about a half inch of bare wire at every fitting so that the joint doesn’t trap water and can be inspected.
Phil Fontaine
Aurora – Ketch #94Post generated from Pearson424 Forum using Mail2Forum
-
Hi Phil,
For SOLAS approved lifelines, as for races like the Newport-Bermuda race, no coating at all is allowed because the line can corrode much farther up the coating and fail.
I'll be replacing mine without the coating – even though it will catch the hair on my arms, legs, and chest. Sorry for being gross, but you need to know the downside.
Bob
On Wed, Jun 25, 2008 at 6:05 PM, Philippe Fontaine < ([email][/email])> wrote:
Perhaps some of you might profit from a recent experience of mine.
On a fairly windy day, while rolling up the jib, a flailing jib sheet broke one of my lifelines at the connection to a gate eye. Inspection of the broken wire revealed that all the strands were badly corroded. My boat is a 1980 (built in 1979) and I believe the lifelines were the original ones.Needless to say the lifelines have now been replaced. The new ones have about a half inch of bare wire at every fitting so that the joint doesn't trap water and can be inspected.
Phil Fontaine
Aurora – Ketch #94—
Bob Fine
Fine Software LLC
Your data on the web your way. No kiddingPost generated from Pearson424 Forum using Mail2Forum
-
When I was looking at boats for sale one had standing rigging where the wires were smoothed over a bit (I know I’m not explaining that well) so the whole strand had a smoother feel to it. When you looked at it closely basically the wires on the outside looked like they had been squished to create a series of closely aligned flat surfaces. Not sure what stuff is called and I remember the broker saying it was expensive, but it might be something to consider.
-p
<.. snip>
Post generated from Pearson424 Forum using Mail2Forum
Owners no more...
Thanks Dawn and Patrick! -
OK, I should have googled first. I think it’s Dyform, but I’m not sure.
http://www.pyacht.com/online-store/scstore/h-dyform_wire.htm
-p
<.. snip>
Post generated from Pearson424 Forum using Mail2Forum
Owners no more...
Thanks Dawn and Patrick!
-
- You must be logged in to reply to this topic.