- This topic has 3 replies, 4 voices, and was last updated 12 years, 11 months ago by
.
-
Posts
-
-
You can direct them into the fwd sink with a small u shaped spout
Adam
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
Post generated from Pearson424 Forum using Mail2Forum
-
Except I’m removing the sink and putting in a drawer…
I’m not being terse. This is from my cell phone and I detest typing on it.
On Nov 26, 2013 1:14 PM, “Mizzenmonkey” wrote:You can direct them into the fwd sink with a small u shaped spout
Adam
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
_______________________________________________
maillist mailing listhttps://pearson424.org/mailman/listinfo/maillist_pearson424.org
Post generated from Pearson424 Forum using Mail2Forum
-
-
I installed a fill gauge on the aft end of both tanks. I installed a tee with a short section of hose mounted to the bulkhead with a ball valve on the end. When filling the tanks I open the valve to allow air to escape and watch the level go up the hose. When full I close the ball valve so the pump doesn’t suck air.
Linus
Live by the currents, plan by the tides and follow the sun
On Nov 26, 2013, at 3:05 PM, “Silverheels” wrote:
Quote:Better make it a watertight drawer.🙂
Quote:
Original Message
Post generated from Pearson424 Forum using Mail2Forum
-
- You must be logged in to reply to this topic.