Forum Replies Created

Viewing 9 posts - 16 through 24 (of 24 total)
  • Author
    Posts
  • in reply to: Hull # List / Registry #222178
    Idyll Ours
    Participant
    125  Idyll Ours  Sloop  Jim Mavis Sanger  jimmavissanger@gmail.com  Sarnia Ontario Canada  June 2013  Westerbeke 60

    This is current info for 125 which used to be TiltnHilton in Sandusky Ohio. I think it could also be interesting if the previous owner information is available and could be displayed.

    Thanks,

                   Jim
    Sent from my iPad
    1 user thanked author for this post.
    in reply to: Profile problems #221632
    Idyll Ours
    Participant
    Mine appears to be ok.
    Thanks,
                  Idyll Ours

    Sent from my iPad

    in reply to: Finally closed deal on my 434 #221353
    Idyll Ours
    Participant
    Congratulations !

    Sent from my iPad

    in reply to: Port replacement #221268
    Idyll Ours
    Participant
    I saw the butyl tape testimonials and I have also found this product fairly easy to use and  very effective for bedding all kinds of hardware on deck. I found the stuff at Princess Auto in Canada (discount stuff of all kinds) which I think is similar to harbour freight in the U.S., the price is similar in $ Cdn for each roll instead of two.

    Sent from my iPad

    in reply to: Cleaning up original portlight lenses #221267
    Idyll Ours
    Participant
    Yes I think I am getting everything.
    Thanks,
                 Jim

    Sent from my iPad

    in reply to: Salon floor sag #220573
    Idyll Ours
    Participant

    I had the whole salon floor sagging basically about an inch or so midway near the centre of both settees. I used a floor jack on top of the keel to eliminate the sag and then inserted a piece of 4 inch square pvc fence post vertically to maintain the elevation. I had cut some addition pvc into an angle shape and inserted it between the four inch vertical and the horizontal “floor joist” to distribute the load. I installed these supports both fore and aft of the mast and have not had any negative consequences yet. I can try to get a picture later this week if you would like.

    in reply to: How do quit? #220558
    Idyll Ours
    Participant
    Hello,
    I received this one, and had no intention of any profile changes so please ensure my status stays intact to receive all information exchange and announcements.
    Thank you,
                        Jim

    Sent from my iPad

    in reply to: Pearson Serial Number Decoding #220390
    Idyll Ours
    Participant
    Yes that’s where I saw it, and it says 72 is for cutter rig but nothing for sloops.

    Sent from my iPad

    in reply to: Profile Photos #220196
    Idyll Ours
    Participant

    Hello all,

    I recall early in our boating lives, while I was drooling over some new gadget or other at a boat show and bemoaning over the high sticker price a gentleman beside me said “you have to get used to it as the only thing cheap on a sailboat is the owner”.

    I resemble that remark so I am also very grateful for access via this web based forum to accomplished craftspeople with knowledge and experience offering free advice on when it is wise to spend the money.

    Thanks all,
    Jim 

Viewing 9 posts - 16 through 24 (of 24 total)